User's Manual
Table Of Contents
- Title page
- Legal notice
- Contents
- List of tables
- 9962 MSEC Maximum Key Hardward Performances (based on Software used)
- Frequency bands
- Transmit Power
- Radio Parameters
- Power LED initialization
- Power LED fault indication
- Faults that set the Power LED hardware failure
- LTE LED startup
- LTE LED fault conditions
- WCDMA LED startup
- WCDMA LED fault condition
- GPS LED
- GPS LED fault condition
- WiFi Status LED initialization states
- List of figures
- About this document
- 1 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Overview
- 2 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Functional Description
- 3 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Hardware
- 4 Troubleshooting using the LED states
- Index
LED states for the 3G and 3G/4G 9962 MSEC v1.0
Overview
This topic describes the states of the LEDs on the 9962 MSEC v1.0 device.
There are two variants of the 9962 MSEC v1.0:
• 3G only
• 3G and 4G (LTE)
There are six red/green bicolored LEDs that indicate the status:
• Power
• LTE cells: only on the 3G/4G variant
• W-CDMA cell
• GPS receiver
• 2 WiFi module status indicators on the rear of the unit, labelled 2G and 5G.
The LEDs can take these states:
• Off
• flashing green
• solid green
• flashing red
• solid red
• toggling between red and green
Figure 4-1 9962 MSEC v1.0 LEDs
Troubleshooting using the LED states LED states for the 3G and 3G/4G 9962 MSEC v1.0
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
4-2
Alcatel-Lucent 9962 MSEC v1.0
3MN-02001-0003-DEZZA
Issue 3 November 2015