User's Manual
Table Of Contents
- Title page
- Legal notice
- Contents
- List of tables
- 9962 MSEC Maximum Key Hardward Performances (based on Software used)
- Frequency bands
- Transmit Power
- Radio Parameters
- Power LED initialization
- Power LED fault indication
- Faults that set the Power LED hardware failure
- LTE LED startup
- LTE LED fault conditions
- WCDMA LED startup
- WCDMA LED fault condition
- GPS LED
- GPS LED fault condition
- WiFi Status LED initialization states
- List of figures
- About this document
- 1 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Overview
- 2 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Functional Description
- 3 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Hardware
- 4 Troubleshooting using the LED states
- Index
LED interpretation
When the 9962 MSEC v1.0 is powered on, all LEDs are solid red: if the software fails to
start, the LEDs remain in this condition. Otherwise the LEDs indicate the progress of the
initialization of the unit.
After the four LEDs, excluding the WiFi LEDs, have been in a normal state for fifteen
minutes, these four LEDs are all turned off to avoid bringing attention to the unit. If an
event occurs that changes an LED state, then the four LEDs are turned on. After the LEDs
have returned to normal state for fifteen minutes, all LEDs are turned off again.
The WiFi status LEDs act independently of this management.
Power LED
The system initialization and fault states are represented by a single bicolored red/green
LED.
Table 4-1 Power LED initialization
System state LED state Description
Power off OFF Power is off
Boot Red Power is applied or the system is reset.
During this phase the BLST is performed, DHCP access
is made and the IP address is assigned.
The system remains in this state if the boot fails or
BLST fails.
Network attach flashing red The system attempts to establish contact with the DNS
external server.
The system negotiates with the Security Gateway and
establishes an OAM IPSec tunnel.
EMS connect Toggling
red/green
Attempt to contact DNS Internal for HDM/SAM address
resolution
Download and
configuration
flashing green The system is verifying the 9962 MSEC v1.0 software
and database.
It updates if necessary, followed by a reset.
System stable Green Software and database are current, and the system is
ready to enable applications
Troubleshooting using the LED states LED states for the 3G and 3G/4G 9962 MSEC v1.0
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
Alcatel-Lucent 9962 MSEC v1.0
3MN-02001-0003-DEZZA
Issue 3 November 2015
4-3