User's Manual
Table Of Contents
- Title page
- Legal notice
- Contents
- List of tables
- 9962 MSEC Maximum Key Hardward Performances (based on Software used)
- Frequency bands
- Transmit Power
- Radio Parameters
- Power LED initialization
- Power LED fault indication
- Faults that set the Power LED hardware failure
- LTE LED startup
- LTE LED fault conditions
- WCDMA LED startup
- WCDMA LED fault condition
- GPS LED
- GPS LED fault condition
- WiFi Status LED initialization states
- List of figures
- About this document
- 1 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Overview
- 2 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Functional Description
- 3 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 : Hardware
- 4 Troubleshooting using the LED states
- Index
Table 4-4 LTE LED startup (continued)
State LED state Description
System
initializing
(timing, RF,
cell) and begin
location check
Toggling
red/green
Establishing resources needed by the LTE cell. The 9962
MSEC v1.0 may leave this state before the location
check completes if
passiveGPS
is True.
Otherwise it remains in this state until the location check
completes.
Location check
failure
flashing red The 9962 MSEC v1.0 remains in this state if the location
check or movement check fails and
showLocationCheck
is True
Unit reset is required to clear the state.
Boot complete Off LED comes on initially but is turned off once the
software starts and
operatingMode
is WCDMA-only.
Cell unlocked
and ready for
service (LTE cell
AST Unlocked
and OST
Enabled)
Green Location check may be running in the background or no
location check to be performed
In the case where a fault is detected, the LED indicates the fault.
Table 4-5 LTE LED fault conditions
LED state Description Comment
flashing green Cell blocked.
LTE cell AST set to
Locked, or OST is
Disabled due to ongoing
Network Listen activity
Cell successfully configured but not
transmitting
The LED fault state clears when the cell is
unlocked or Network Listen completes and
OST is now Enabled.
Red Cell failure
LTE cell OST is Disabled
for any reason other than
ongoing Network Listen
activity
cell configuration failure, cell operational
failure reported by 3G application, WCDMA
tunnel down, SCTP association failure or
another fault.
The LED fault state clears when the cell is
reconfigured and unblocked.
Troubleshooting using the LED states LED states for the 3G and 3G/4G 9962 MSEC v1.0
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
Alcatel-Lucent 9962 MSEC v1.0
3MN-02001-0003-DEZZA
Issue 3 November 2015
4-5