User's Manual

WiFi LEDs
These LEDs indicate the state of the WiFi module. They are driven directly from the WiFi
module itself and not by the Multi-Standard Small Cell OAM software. Expected LED
states are documented below.
The WiFi LEDs are extinguished during normal activity like the other LEDs.
The WiFi LEDs are located on the WiFi module on the rear of the 9962 MSEC v1.0
hardware. The 2G label corresponds with the 2.4 GHz segment while the 5G label
corresponds with the 5 GHz segment.
The table describes the initialization steps of the 2G and 5G WiFi LEDs.
Table 4-10 WiFi Status LED initialization states
Step Description State 5G LED 2G LED
1 Power-up or reload BOOTING Solid On Solid On
2 AP tries to get adopted by
controller
ADOPTING Slow
blinking
Off
3 (optional) controller pushes a
software upgrade
UPGRADING Off Slow
blinking
4 The controller pushes the AP
configuration
CONFIGURING Fast blinking Fast blinking
5 WLAN are mapped to radios:
normal service
OPERATIONAL 5GHz
service: Slow
blinking
2.4GHz
service: Slow
blinking
6 After 30
1
minutes in the same
state
HIDING Off Off
Figure 4-2 WiFi LEDs
Troubleshooting using the LED states LED states for the 3G and 3G/4G 9962 MSEC v1.0
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
4-8
Alcatel-Lucent 9962 MSEC v1.0
3MN-02001-0003-DEZZA
Issue 3 November 2015