User's Manual
Table Of Contents
- Title page
- Legal notice
- Contents
- List of tables
- List of figures
- Multi-standard Enterprise Cell v1 antennas
- 9962 MSEC v1.0 mounting plate
- 9962 MSEC v1.0 stick antennas
- Notch, groove and lock locations
- Mounting plate on the 9962 MSEC v1.0 access point
- 9962 MSEC v1.0 integrated antennas
- 9962 MSEC v1.0 external antenna connector
- 9962 MSEC v1.0 integrated antennas
- 9363 access point replacement
- Backhaul connection - Star configuration - 2 options
- 9962 MSEC v1.0 connectors
- Example of 9962 MSEC v1.0 daisy chain
- 9962 MSEC v1.0 front LEDs
- 9962 MSEC v1.0 Wi-Fi LEDs
- About this document
- 1 Safety and general information
- 2 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 installation
- 3 Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1 commissioning
- 4 Post-installation activities
- Appendix A: Product conformance statements
- Glossary
- Index
• Calibrations, special tests after repairs, and regular safety checks must be carried out,
documented, and archived.
• Follow applicable hazardous waste, electronic scrap, and take-back disposal
procedures.
Other important safety instructions
Observe the following safety instructions, they are of particular importance for your
safety:
• Be familiar with evacuation plans and emergency telephone numbers.
• Ensure first-aid kits are available.
• Wear appropriate personal protective equipment (PPE) such as safety glasses, hard
hats, gloves, and fall protection.
• Never wear jewelry (rings, bracelets, watches, etc.) when working on or near
energized equipment.
Summary of equipment safety instructions
Observe the following safety instructions while working with the equipment:
• This product is to be installed only in restricted access areas.
• This product should be only operated from the type of power source indicated on the
marking label.
• This product must be provided with a readily accessible disconnect device as part of
the building installation.
• Installation must include an independent frame ground drop to the building ground.
Refer to the Hardware Installation Guide.
• For information on correct mounting instruction, refer to the Hardware Installation
Guide.
• Install only equipment identified in the Hardware Installation Guide provided with
this product. Use of other equipment may result in improper connection of circuitry
leading to fire or injury to persons.
• To reduce the risk of electrical shock, do not disassemble this product. Only trained
personnel should install and service this product. Opening or removing covers and/or
circuit boards may expose you to dangerous voltages or other risks. Incorrect
reassembly can cause electrical shock when the unit is subsequently used.
• Slots and openings in this product are provided for ventilation. To protect the product
from overheating, these openings must not be blocked or covered. This product
should not be placed in a built-in installation unless proper ventilation is provided
Safety and general information Basic safety aspects
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1-8
Alcatel-Lucent 9962 MSEC v1.0
3MN-02001-0002-RJZZA
Issue 2.01 September 2015
P
RELIMINARY
P
RELIMINARY