User Manual

Wireless Access Point User Guide
10
Setup using a Web Browser
Your Browser must support JavaScript
. The configuration program has been tested on the
following browsers:
•
Netscape V4.08 or later
•
Internet Explorer V4 or later
Setup Procedure
Before commencing, install the Wireless Access Point in your LAN, as described previously.
1. Check the Wireless Access Point to determine its Default Name. This is shown on a label
on the base or rear, and is in the following format:
SCxxxxxx
Where xxxxxx is a set of 6 Hex characters ( 0 ~ 9, and A ~ F ).
2. Use a PC which is already connected to your LAN, either by a wired connection or an-
other Access Point.
•
Until the Wireless Access Point is configured, establishing a Wireless connection to it
may be not possible.
•
If your LAN contains a Router or Routers, ensure the PC used for configuration is on
the same LAN segment as the Wireless Access Point.
3. Start your Web browser.
4. In the Address box, enter "HTTP://" and the Default Name of the Wireless Access Point
e.g.
HTTP://SC2D631A
5. You should then see a login prompt, which will ask for a User Name and Password.
Enter
admin
for the User Name, and
password
for the Password.
These are the default values. The password (but not the user name) can and should be
changed. Always enter the current password, as set on the Admin Login screen.
Figure 6: Password Dialog
6. You will then see the Status screen, which displays the current settings and status. No data
input is possible on this screen.