User's Manual

Introduction

Rear Panel

Figure 3 Rear Panel

Antennae

Two antennae (aerial) are supplied. Best results are usually obtained

with the antenna in a vertical position.

Power port

Connect the supplied power adapter here.

Reset Button

This button has two (2) functions:

• Reboot. When pressed and released, the Wireless Access Point

will reboot (restart).

• Reset to Factory Defaults. This button can also be used to clear

ALL data and restore ALL settings to the factory default values.

To Clear All Data and restore the factory default values:

1. Power on the Access Point.

2. Hold the Reset Button down until the Status (Red) LED blinks

TWICE.

3. Release the Reset Button.

The factory default configuration has now been restored, and the

Access Point is ready for use.

Ethernet

Use a standard LAN cable (RJ45 connectors) to connect this port to a

10BaseT or 100BaseT hub on your LAN.