User Manual

Wireless Access Point User Guide
8
Wireless Access Points
On the center of the screen is a list of all Wireless Access Points found on the network. For
each device, the following data is shown:
• Server Name. The Server Name is shown on a sticker on the base of the device.
• IP. The IP address for the Wireless Access Point.
• MAC. The hardware or physical address of the Wireless Access Point.
• SSID. The SSID setting for the Wireless Access Point. (The SSID is case sensitive.)
• Channel. The current channel used by the Wireless Access Point.
• Version. The current version number for the Wireless Access Point.
• Description. Any extra information for the Wireless Access Point.
Note: If the desired Wireless Access Point is not listed, check that the device is installed and
ON, then Refresh the list.
Buttons
• Refresh. Click this button to update the Wireless Access Point device listing after chang-
ing the name or IP Address.
• Web Management. You can use this button to connect the Wireless Access Point to do
some setup using web browser.
• Set IP Address. Click this button if you want to change the IP Address of the device.
• Exit. Exit the Management utility program by clicking this button.
Setup Procedure
1. Select the desired Wireless Access Point.
2. Click the Set IP Address button.
3. If prompted, enter the user name and password. The default values are admin for the User
Name, and a blank Password
4. Ensure the IP address, Network Mask, and Gateway are correct for your LAN. Save any
changes.
5. Click the Web Management button to connect to the selected Wireless Access Point using
your Web Browser. If prompted, enter the User Name and Password again.
6. Configure the following screens, using the on-line help if necessary.
The following section also provides more details about each of these screens.
• Wireless
• Security
• Password
7. Setup is now complete.