User Manual

2
Chapter 2
Initial Configuration
This Chapter covers the initial configuration of the Wireless 3-in-1 Compan-
ion.
Requirements
• Network cable. Use a standard 10/100BaseT network (UTP) cable with RJ45 connectors.
• TCP/IP protocol must be installed on your PC.
• To use the Wireless interface, your PC must be compliant with the IEEE802.11b or
IEEE802.11g specifications.
Procedure
1. Use the mode selector switch on the side on the Wireless 3-in-1 Companion to select
"Config" mode.
2. Power up and wait for the Wireless LED to turn on. This indicates the Wireless 3-in-1
Companion is ready.
3. Establish a Wired or Wireless connection to the Wireless 3-in-1 Companion (a Wired
connection is recommended).
• Wired - connect a standard LAN cable from your PC's 10/100BaseT Ethernet port to
the Ethernet port on the Wireless 3-in-1 Companion.
• Wireless - select the wireless network with the SSID
default
4. Start your Web browser.
5. In the "Location" or "Address" bar, enter the following:
config.ap
• This will work only while in Config mode.
In AP mode, you cannot connect.
In Router mode, you must connect using the Wireless LAN IP address.
• This may not work if using a wireless connection and your PC also has an active
10/100BaseT Ethernet connection.
6. By default, the admin password is blank, and you will NOT be prompted for a username
and password.
If the admin password has been set (on the System screen), you will be prompted for the
username and password.
• Enter
admin for the user name.
• Enter the current password.
7. You will then see the Mode Configuration screen.
8