User Manual

Installation
No login…
If you check this, and provide the MAC address of your PC (see
above), then you will not be prompted for the password when you
connect using your PC.
You should set a password for the admin login, using the pass-
word fields below. This option is provided to allow you to set a
password, but avoid the inconvenience of being prompted for the
password whenever you wish to change the settings.
Change Admin login
This login is required to change any settings on the Wireless 3-in-
1 Companion. (By default, the password is blank, so the first time
you connect, you are not prompted for the password.)
Check this box if you wish to change the current password, and
then enter the required password in the fields below. If this check-
box is enabled, and the password fields left blank, then the
password is cleared (set to no password.
New Password
Enter the new password here.
Note that if the password is set, you will be prompted for the user
name and password when you connect. You must use admin as
the user name.
Verify Password
Re-enter the new password in this field, to ensure it is correct.
System
Device Name
The name of the Wireless 3-in-1 Companion. You can change this
if you wish.
Firmware version
This displays the current version of the firmware.
Click the Upgrade Firmware button if you wish to install a new
version of the firmware.
• You need to have downloaded the new firmware file first.
• Clicking the button will display the Upgrade Firmware
screen. See the following section for further details.
Config File
This feature allows you to download (save) the current settings to
a file on your PC, upload (restore) a previously-saved config file.
Click the desired button:
• Download will prompt you for the location, on your PC, for
the configuration file.
• Upload will display the Config File screen. See below for
details.
11