User Manual

3
Chapter 3
Setup - AP Mode
This Chapter provides Setup details for the AP mode of the Wireless 3-in-1
Companion.
Overview
You can NOT connect to the Wireless 3-in-1 Companion while it is in AP (Access Point)
mode. Configuration for AP mode must be performed while in Config Mode.
Note:
By default, the Wireless 3-in-1 Companion will allow both 802.11b and 802.11g connections.
Connecting
1. Use the mode selector switch on the side on the Wireless 3-in-1 Companion to select
"Config" mode.
2. Power up and wait for the Wireless LED to turn on. This indicates the Wireless 3-in-1
Companion is ready.
3. Establish a Wired or Wireless connection to the 3-in-1.
• Wired - connect a standard LAN cable from your PC's 10/100BaseT Ethernet port to
the Ethernet port on the Wireless 3-in-1 Companion.
• Wireless - select the wireless network with the SSID
default
4. Start your Web browser.
5. In the "Location" or "Address" bar, enter the following:
config.ap
Note: This will work only while in Config mode.
6. If the admin password has been set (on the System screen), you will be prompted for the
username and password.
• Enter
admin for the user name.
• Enter the current password.
7. You will then see the Mode Configuration screen.
Click the "Config" button for AP Mode, to view the AP Setup screen.
14