User Manual

Wireless 3-in-1 Companion User Guide
Login Method
The login method is the type of connection used on the Ethernet
(WAN) port.
• The default value is "Travel Mode (Hotel)". This mode requires
no additional information to be input.
• To change the Login method, click the Configure button.
Connection Status
This indicates the current status of the connection on the Ethernet
(WAN) port.
This can only show "Connected" if the Wireless 3-in-1 Companion is
in AP/Router mode.
DMZ PC
The DMZ PC will receive all incoming traffic for which the correct
destination PC is unknown.
• This field shows the current DMZ PC.
• The default value is "None", meaning the DMZ feature is dis-
abled.
Wireless LAN
AP/Router IP
Address
The IP address of the Wireless 3-in-1 Companion on the Wireless
LAN.
• The default value is 192.168.0.1
• If you wish to change any settings while in AP/Router mode, you
must connect to the Wireless 3-in-1 Companion using this IP ad-
dress.
• Normally, it is not necessary to change this IP address.
• You MUST change this address if the LAN/WAN on the
Ethernet (WAN) port is using the same IP address range
(192.168.0.1 ~ 192.168.0.254).
The recommended value to change to is 192.168.1.1
Note: In AP/Router mode, the Wireless 3-in-1 Companion has 2 IP
addresses, one for the Wireless interface, and another for the Ethernet
(WAN) port.
Subnet Mask
The subnet mask for the IP address above.
The default value is 255.255.255.0, which is the standard value for
small networks.
Enable DHCP
Server for
Wireless clients
The DHCP Server will provide an IP address and related information
to Wireless clients when they connect to the Wireless 3-in-1 Compan-
ion.
• The default value is Enabled.
• It is strongly recommended that this feature be enabled.
Do not disable this feature unless you have a good reason to do
so.
24