User Manual

3. If used as router, use a standard LAN cable to connect the “Wan” port on the Wireless
Access Point to DSL modem.
4. Connect the supplied power adapter to the Wireless Access Point and a convenient
power outlet, and power up.
5. Check the LEDs:
• The Power, Wireless LAN, and LAN LEDs should be ON.
3. Access Point Setup
The default settings are:
• SSID: Thomson
• WPA-PSK: Enabled
• Key: Generate from MAC address
If you need to change these, follow this procedure.
1. Check the Wireless Access Point to determine its Default Name. This is shown on a
label on the base or rear, and is in the following format:
SCxxxxxx
Where xxxxxx is a set of 6 Hex characters ( 0 ~ 9, and A ~ F ).
2. Use a PC which is already connected to your LAN, either by a wired connection or
another Access Point.
• Until the Wireless Access Point is configured, establishing a Wireless connection
to it may be not possible.
• If your LAN contains a Router or Routers, ensure the PC used for configuration is
on the same LAN segment as the Wireless Access Point.
3. Start your Web browser.
4. For the Address enter "HTTP://" and the Default IP of the Wireless Access Point
e.g. HTTP://192.168.0.1
5. You should then see a login prompt, which will ask for a User Name and Password.
Enter admin for the User Name, and leave the Password blank. These are the default
values. If they are changed, use the current values.
6. You will then see the Status screen, which displays the current settings and status. No
data input is possible on this screen.
7. From the menu, select and configure the following options, using the on-line help if
necessary.
8. Setup of the Wireless Access Point is now complete.