User Manual

Setup
11
HomePlug Settings
This screen can be reached via the HomePlug Settings link on the main menu.
Figure 6: HomePlug Settings Screen
This screen allows you to set the HomePlug Network Password for the HomePlug 802.11g
Access Point as well as other HomePlug stations (devices) on your network. All HomePlug
devices must use the same HomePlug Network Password in order to communicate with each
other.
You can also use this screen to assign a new Network Password to other HomePlug stations on
your HomePlug Network. To do this:
1. Enter the Device Passcodes of each HomePlug stations on your LAN.
Each HomePlug station has a unique Passcode in the format xxxx-xxxx-xxxx-xxxx, usually
shown on a label on the rear or base of the HomePlug device.
2. When completed, click "Save" to save the list (or click "Cancel" if you decide to discard
your changes).
3. Select the HomePlug stations you wish to assign the Network Password to.
4. Click the "Set Network Password" button.
5. A confirmation message will appear confirming the success of the password change for
each device. An error message will appear if any device is not able to be reset to the new
network password.