User's Manual

Advanced Administration
87
Figure 49: Routing Screen
Data - Routing Screen
RIP
Enable RIP V1 Check this to enable the RIP (Routing Information Protocol) feature of
the Broadband Router
The Wireless Router supports RIP 1 only.
Static Routing
Static Routing
Table Entries
This list shows all entries in the Routing Table.
The "Properties" area shows details of the selected item in the
list.
Change any the properties as required, then click the "Update"
button to save the changes to the selected entry.
Properties
Destination Network - The network address of the remote LAN
segment. For standard class "C" LANs, the network address is
the first 3 fields of the Destination IP Address. The 4th (last) field
can be left at 0.
Network Mask - The Network Mask for the remote LAN seg-
ment. For class "C" networks, the default mask is 255.255.255.0
Gateway IP Address - The IP Address of the Gateway or Router
which the Wireless Router must use to communicate with the
destination above. (NOT the router attached to the remote seg-
ment.)
Metric - The number of "hops" (routers) to pass through to
reach the remote LAN segment. The shortest path will be used.
The default value is 2.
Buttons
Save Save the RIP setting. This has no effect on the Static Routing Table.