User's Manual

 Off - Cloud service is not available.

 Flashing - Cloud service is not sending data properly.

ZigBee

(Green)

 On - ZigBee mode is selected.

 On (5 seconds) - ZigBee sensor added or synchronization is suc-

cessful.

 Off - ZigBee module is in idle mode.

 Flashing - ZigBee module is in active mode.

Bluetooth

(Green)

 On - Bluetooth mode is selected.

 On (5 seconds) - Bluetooth sensor added or synchronization is

successful.

 Off - Bluetooth module is in idle mode.

 Flashing - Bluetooth module is in active mode.

Rear/Side Panel

Power Port

Connect the supplied power adapter here.

ETHERNET

Port

Use a standard LAN cable (RJ45 connector) to connect your PC to the

port.

USB Port

The connector is USB host with support for mass storage device.

Select Button

 Push the Select button on the device to choose the desired RF mode

(WiFi/Z-Wave/ZigBee/Bluetooth), and then the LED of the selected

mode will be on.

 Push the Select button for three seconds again to unselect the RF

mode if needed.

Sync Button

 After selecting the RF mode, push the Sync button to synchronize

the gateway and sensors.

 Push the Sync button for three seconds again to stop the synchroni-

zation process if needed.

Reset

This button has two (2) functions:

 Reboot. When pressed and released, the Multiple RF Home

Gateway will reboot (restart).

 Clear All Data. This button can also be used to clear ALL data

and restore ALL settings to the factory default values.

To Clear All Date and restore the factory default values:

1. Power On.

2. Keep holding the Reset Button down for 3 seconds.

Release the Reset Button. The Multiple RF Home Gateway is now using

the factory default values.