User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Video Server
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (Wireless Model Only)
- DDNS Screen
- IP Filter Screen
- I/O Port Screen
- RS485 Screen
- Streamings
- Video & Audio Screen
- Video Access Screen
- User Database Screen
- Motion Detection Screen
- Audio Detection Screen
- E-Mail Screen
- FTP Screen
- HTTP Screen
- SMB/CIFS Client Screen
- Event Trigger Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 WindowsViewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Network Camera HTTP CGI
…
content-type: text/plain \r\n
...
\r\n
[MOTION]
.... Å Please refer to the chapter [MOTION] group in Configuration file Spec
document.
\r\n
Set Motion Detection Settings
Method: GET
URL:
http://<IP>/adm/set_group.cgi?group=MOTION&<parameter>=<value>…
(Please refer to Set group parameters command and Configuration file Spec
document.)
Return:
HTTP/1.0 200 OK\r\n
…
content-type: text/plain\r\n
\r\n
OK\r\n
Notes:
In some special models (the first motion window is used for full screen), the S/W (OCX) side needs to do it
as the following way (without changing any configure item):
1. Use “md_switch1” as the switch of “full screen” or “sub-windows”.
2. The md_window1 always sets to 640x480 size.
If “md_switch1=1”, then the camera needs to detect in the whole screen video. The OCX can’t allow the
user to configure the rest windows (sub-window 1~3).
If “md_switch1=0”, then the camera will detect in the “md_window2~4” area. (It’s the same as the sub-
windows 1~3.)
102