User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Video Server
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (Wireless Model Only)
- DDNS Screen
- IP Filter Screen
- I/O Port Screen
- RS485 Screen
- Streamings
- Video & Audio Screen
- Video Access Screen
- User Database Screen
- Motion Detection Screen
- Audio Detection Screen
- E-Mail Screen
- FTP Screen
- HTTP Screen
- SMB/CIFS Client Screen
- Event Trigger Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 WindowsViewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Network Camera HTTP CGI
Setup using the Windows Wizard
Initial setup should be performed using the supplied Windows-based setup Wizard. This
program can locate the Video Server even if its IP address is invalid for your network. You can
then configure the Video Server with appropriate TCP/IP settings for your LAN.
Subsequent administration can be performed with your Web browser, as explained in Chapter
5 - Web-based Management.
Setup Procedure
1. Insert the supplied CD-ROM into your drive. If the setup program does not start
automatically, run NetworkCamera.exe in the root folder.
• You will see the Welcome screen shown below.
• Click the Setup button to start the setup Wizard.
Figure 3: Welcome Screen
2. The next screen, shown below, will list all the Video Servers on your LAN.
Figure 4: Camera List Screen
6