User's Manual

Physical Details - Video Server

Front - Video Server

Figure 1: Front Panel

RESET button

This button is recessed; you need a pin or paper clip to press it. It

can be activated at any time the video server is in the "ready" mode.

• Reset to manufacturer default value and reboot. When

pressed and held over 10 seconds, the settings of Video Server

will be set to their default values.

Note:

After this procedure is completed, the Power LED will blink three

times to confirm that the reset was completed successfully.

CH1~CH4

Each channel includes a video in port and an audio in port.

• Video in: It supports a single composite video source by using a

BNC connector.

• Audio in: If required, an external microphone can be attached

here. Microphones designed to be used with PCs are usually

compatible with this microphone input.

Output Channel

This channel includes a video in port and an audio in port.

• Video in: Loop-through connection to the video signal from the

Video In connector. It allows direct connection to an external

monitor.

• Audio in: If required, an external microphone can be attached

here.

• Video Channel Switch: Push this button to switch the monitor

between the 4 input channels (CH1, CH2, CH3, CH4, CH1~4).

WPS Button

Push the WPS button on the device and on your other wireless

device to perform WPS function that easily creates an encryption-

secured wireless connection automatically.

• WPS PBC Mode. When pressed and released (less then 3

seconds), the Network Camera will be in the WPS PBC mode

(Auto link mode).

• WPS Pin Code Mode. When pressed and held for over 3

seconds, the Network Camera will be in the WPS Pin Code

mode.