User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Network Camera
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen
- DDNS Screen
- IP Filter
- Streamings
- Video & Audio Screen
- Video Access Screen
- User Database Screen
- Motion Detection Screen
- Audio Detection Screen
- E-Mail Screen
- FTP Screen
- HTTP Screen
- SMB/CIFS Client Screen
- Event Trigger Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 WindowsViewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Network Camera HTTP CGI
Rear - Network Camera
Figure 3: Rear Panel
Antenna
Attach the supplied antenna here. The antenna is adjustable; best
results are usually obtained with the antenna positioned vertically.
Power Input
Connect the supplied 12V power adapter here. Do not use other
power adapters; doing so may damage the camera.
Reset Button
This button is recessed; you need a pin or paper clip can be used to
depress it. It can be activated at any time the camera is in the
"ready" mode.
• Reset to manufacturer default valued and reboot. When
pressed and held over 10 seconds, the settings of Network
Camera will be set to their default values.
LAN port
Use a standard LAN cable to connect your Network Camera to a
10/100BaseT hub or switch.
Note:
• Plugging in the LAN cable will disable the Wireless interface.
Only 1 interface can be active at any time.
• The LAN cable should only be connected or disconnected when
the camera is powered OFF. Attaching or detaching the LAN
cable while the camera is powered on does NOT switch the
interface between wired and wireless.
Speaker
The built-in speaker is mounted on the back.
5