User's Manual

Chapter 2
Basic Setup
This section provides information on how to assemble and configure
the OC835-ADT Outdoor HD Camera.
Installation
1. Assemble the Camera
Attach the Camera Stand to the camera.
2. Make the Connection
Using a Wired Connection
If you are using a wired connection to the OC835-ADT, connect a Micro USB
to RJ-45 Adapter Cable (not included) to the USB port of the camera. Then use
a standard Ethernet cable (not included) to connect to the Pulse Gateway or
Total Security (TS) Base panel.
Figure 4: Wired Network Connection
Using a Wireless Connection
The wireless (WPS) connection between the camera and the Pulse Gateway or
Total Security (TS) Base panel is performed during the Pulse enrollment. This
process is detailed starting on page 13.
NOTE:
The Wireless and LAN interfaces cannot be used
simultaneously. Making a wired LAN connection disables the
wireless interface.
3. Power Up
Connect the supplied 12V power adapter to the camera and power up. Use
only the power adapter provided. Using a different one may cause hardware
damage.
2
OC835-ADT Outdoor HD Camera Installation Guide 7