User's Manual

Chapter 2 Basic Setup
Use only the power adapter provided. Using a different one can
result in hardware damage.
Figure 5: Routing the Power Cable
The Power LED turns on briefly, and then starts blinking. (The Power LED will
continue to blink during startup, which takes about one minute. After startup is
completed, the Power LED should remain ON.)
4. Check the LEDs
x Power LED. At power up, the Power LED turns on briefly, and then starts
blinking, which takes about one minute. After startup has completed, the
Power LED remains on.
x Network/WPS LED. At power up, the Network/WPS LED is off.
(The Network/WPS LED will flash amber when the camera attempts to
connect wirelessly to the Pulse Gateway / TS Base. The Network/WPS
LED will turn solid green when the wireless connection is successful.)
5. Enroll the Camera in ADT Pulse
This process is described in the next chapter, ADT Pulse Enrollment.
6. Mount the Camera
Place the camera in a location near a power source. For mounting on a wall
using the mounting plate, see Chapter 4 Wall Mounting on page 21.
Mounting Suggestion
To get the best video quality for targets at night, make sure that the camera’s
field of view does not include a large foreground object, such as tabletop or
side wall. If installing on a tabletop, place the camera as close to the edge as
possible. If installing on a wall, angle the camera so that a minimal portion of
the wall is visible.
8 OC835-ADT Outdoor HD Camera Installation Guide