RP101v2 Wireless Repeater Manual Guide
Introduction Overview The RP101v2 is Wireless Repeater, you can use this device to extend your existing Wireless network. Physical Details Figure 1: RP101v2 (Wireless Repeater) LEDs Power (Green) On – Power on / Normal operation. Off - No power.
Signal Quality (Repeater <-> AP) The connection between the RP101v2 and Root AP (access point) or Wireless Router. Off - No associate to Root AP (access point) or Wireless Router Green - The Wireless Link Rate is best Amber - The Wireless Link Rate is good Red - The Wireless Link Rate is poor Signal Quality (Repeater <-> Client) The connection between the RP101v2 and IP camera or computer or mobile device.
Ethernet (Green) On - Ethernet connection is active. Off - No Ethernet connection. Flashing - Data is being transmitted or received via the Ethernet Port.
Setup To extend the range of your Wireless network, you must connect the RP101v2 to your existing Wireless network. You can connect with WPS button or with RP101v2’s Easy Setup. Connect with WPS 1. Locate the RP101v2 near your Wireless router or access point while doing the configuration. 2. Make sure the Root AP (access point) or Wireless Router is on and working properly. 3. Plug the RP101v2 into the AC power slot, then the Power will remain on. LED 4.
The RP101v2 (Wireless Repeater) is now ready for use. Connect with RP101v2’s Easy Setup You can use a web browser to connect to the RP101v2 and set it up. 1. Locate the RP101v2 near your Root AP (access point) or Wireless Router while doing the configuration. 2. Make sure the Root AP (access point) or Wireless Router is on and working properly. 3. Plug the RP101v2 into the AC power slot, then the Power will remain on. LED 4.
6. Select a Wireless network to extend and click the Next button. 7. In the Password (Network Key) field, type the network password (also called passphrase or security key) of Root AP (access point) or Wireless Router.
. In the Range Extender Name (SSID) field, type a name (SSID) for your RP101v2’s Wireless network and click the Next button. 9. Click the Save button, then the RP101v2 will reboot and the settings are applied.
The RP101v2 (Wireless Repeater) is now ready for use. 10. Use a Wireless network manager on the computer or mobile device to connect to the RP101v2’s newly created Wireless network. Example : The wireless setting of RP101v2 is as below: SSID : MyAP Security : WPA2-PSK (AES) Password (Network Key) : 1234567890 You also can use an Ethernet cable to connect a computer to the Ethernet port on the RP101v2.
Appendix A Specifications Network Camera Model Wireless Repeater Dimensions 40.7mm x 57mm x 91.7mm Operating Temperature 0 C to 40 C Frequency Band 2.4 G PHY Rate Up to 300 Mbps Storage Temperature -20 C to 70 C Network Protocols TCP/IP, HTTP, DHCP, NTP Network Interface 1 Ethernet 10/100BaseT LAN connection Wireless interface IEEE 802.11n/802.11b/802.
Regulatory Approvals FCC Statement This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
