User's Manual

Page 4

Setup

To extend the range of your Wireless network, you must connect

the RP101v2 to your existing Wireless network. You can connect

with WPS button or with RP101v2’s Easy Setup.

Connect with WPS

1. Locate the RP101v2 near your Wireless router or access point

while doing the configuration.

2. Make sure the Root AP (access point) or Wireless Router is on

and working properly.

3. Plug the RP101v2 into the AC power slot, then the Power

LED

will remain on.

4. Press the WPS button on the side panel of the RP101v2 and

hold for greater than 8 seconds. The WPS LED

blinks.

5. Within two minutes, press the WPS button on your Root AP

(access point) or Wireless Router. The WPS LED

on the

RP101v2 lights solid green, the Signal Quality LED

lights, and the RP101v2 is connected to your existing Wireless

network.

Note : If the Signal Quality LED

does not light, try

again.

6. On your computer or Wireless device, find the RP101v2 wire-

less network name. The wireless network name (SSID) of

RP101v2 is same as Root AP’s.

Connect your existing Wireless devices to the RP101v2. Use

the same wireless password that you use for your Root AP

(access point) or Wireless Router.