User Manual

Introduction
Viewing Device Statistics
Cisco RV 120W Administration Guide 26
1
• Multicast—The number of multicast packets sent over this radio.
• Collisions—The number of packet collisions reported to the AP.
AP Statistics
This table displays transmit/receive data for a given AP.
• AP Name—The name of the AP.
• Packets—The number of transmitted/received (tx/rx) wireless packets on
the AP.
• Bytes—The number of transmitted/received (tx/rx) bytes of information on
the AP.
• Errors—The number of transmitted/received (tx/rx) packet errors reported
to the AP.
• Dropped—The number of transmitted/received (tx/rx) packets dropped by
the AP.
• Multicast—The number of multicast packets sent over this AP.
• Collisions—The number of packet collisions reported to the AP.
• Poll Interval—Enter a value in seconds for the poll interval. This causes the
page to re-read the statistics from the router and refresh the page
automatically. To modify the poll interval, click the Stop button and then click
Start to restart automatic refresh.
Viewing the IPsec Connection Status
This page displays the status of IPSec connections. You can change the status of a
connection to either establish or disconnect the configured SAs (Security
Associations).
• Policy Name—The name of the IKE or VPN policy associated with this SA.
• Endpoint—Displays the IP address of the remote VPN gateway or client.
• Tx K B —The data transmitted (in KB) over this SA.
• Tx Pac ke t s—The number of IP packets transmitted over this SA.
• State—The current status of the SA for IKE policies. The status can be Not
Connected or IPsec SA Established.