User Manual

Configuring Networking
Configuring Port Management
Cisco RV 120W Administration Guide 52
2
• MD5 Key ID—Input the unique MD-5 key ID used to create the
Authentication Data for this RIP v2 message.
• MD5 Auth Key—Input the auth key for this MD5 key, the auth key that is
encrypted and sent along with the RIP-V2 message.
• Not Valid Before—Enter the start date when the auth key is valid for
authentication.
• Not Valid After—Enter the end date when the auth key is valid for
authentication.
STEP 5 Click Save.
Configuring Port Management
The Cisco RV 120W has four LAN ports. You can enable or disable ports,
configure if the port is half- or full-duplex, and set the port speed.
To configure LAN ports:
STEP 1 Choose Networking > Port Management.
STEP 2 To enable a port, check the Enable box. To disable the port, uncheck the Enable
box. By default, all ports are enabled.
STEP 3 Check the Auto box to let the router and network determine the optimal port
settings. By default, automatic mode is enabled. This setting is available only when
the Enable box is checked.
STEP 4 (Optional) Choose either half- or full-duplex based on the port support. The default
is full-duplex for all ports. This setting is available only when the Auto check box is
unchecked.
STEP 5 (Optional) Select one of the following port speeds: 10 Mbps or 100 Mbps. The
default setting is 100 Mbps for all ports. This setting is available only when the
Auto check box is unchecked. You can change the port speed if a network is
designed to run at a particular speed, such as 10 Mbps mode. In this case, the
endpoint also uses 10 Mbps mode either by auto-negotiation or manual setting.
STEP 6 Click Save.