User's Manual

Configuring Networking
Configuring Port Management
Cisco RV180/RV180W Administration Guide 46
2
DRAFT - CISCO CONFIDENTIAL
2M, check the Enable box. (You must also choose the direction as explained in
Step 2.)
STEP 5 If you enabled RIP v2 authentication, enter the following first and second key
parameters:
• MD5 Key ID—Input the unique MD-5 key ID used to create the Authentication
Data for this RIP v2 message.
• MD5 Auth Key—Input the auth key for this MD5 key, the auth key that is
encrypted and sent along with the RIP-V2 message.
• Not Valid Before—Enter the start date when the auth key is valid for
authentication.
• Not Valid After—Enter the end date when the auth key is valid for
authentication.
STEP 6 Click Save.
Configuring Port Management
The Cisco RV180/RV180W has four LAN ports. You can enable or disable ports,
configure if the port is half- or full-duplex, and set the port speed.
To configure LAN ports:
STEP 1 Choose Networking > Port Management.
STEP 2 In the Port Management Setting Table, to enable a port, check the Enable box. To
disable the port, uncheck the Enable box. By default, all ports are enabled.
STEP 3 Check the Auto Negotiation box to let the firewall and network determine the
optimal port settings. By default, automatic mode is enabled. This setting is
available only when the Enable box is checked.
STEP 4 Check the Flow Control box to enable flow control.
STEP 5 (Optional) Choose either half- or full-duplex based on the port support. The default
is full-duplex for all ports. This setting is available only when the Auto check box is
unchecked.