User's Manual

Configuring the Wireless Network (Cisco RV180W)
Configuring Wi-Fi Protected Setup
Cisco RV180/RV180W Administration Guide 70
3
DRAFT - CISCO CONFIDENTIAL
To change the interval at which APs are displayed in the table, enter the seconds in
the Poll Interval field. You can click Start or Stop to stop the collection of data that
will be displayed in the table.
Adding and Editing Authorized APs
To add or edit authorized APs:
STEP 1 Choose Wireless > Rogue AP > Authorized APs.
STEP 2 Click Add or check the box of an authorized AP and click Edit.
STEP 3 Select the following information:
• MAC Address—The MAC, or hardware, address of the AP.
• SSID—The broadcast name of the SSID.
• Security—The type of security the AP uses.
• Encryption—The type of encryption the AP uses.
• Authentication—The type of authentication the AP uses.
• Network Mode—The type of network on the AP.
• Channel—The wireless channel of the AP.
STEP 4 Click Save.
Configuring Wi-Fi Protected Setup
You can configure Wi-Fi Protected Setup (WPS) on the Cisco RV180W to allow
WPS-enabled devices to more easily connect to the wireless network.
STEP 1 Choose Wireless > WPS.
STEP 2 In the VA P field, select the wireless network on which you want to enable WPS.
The network must use WPA, WPA2, or WPA+WPA2 security.