Englewood Small Cell Model: SCE4255W Quick Installation Guide Manufacture By: Sercomm Corporation 8F, No. 3-1, YuanQu Street, Nankang, Taipei 115, Taiwan, R.O.C.
Table of Contents CHAPTER 1 INTRODUCTION .............................................................................................. 1 Package Contents .............................................................................................................. 1 Key Feature ........................................................................................................................ 1 LEDs ........................................................................................................
Chapter 1 Introduction 1 Englewood is an indoor, self-configuring small cell device that will be used to CBRS network and LTE coverage at the customer premises. Package Contents Package will include following items: 1 x Englewood SCE4255W Device 1 x AD/DC Power Supply Adapter If any of the above items are damaged or missing, please contact your dealer immediately.
LEDs Englewood has 4 LED indicators: Power, LTE(Small cell), and WAN.
Front & Rear Panel Front Panel & back side Interface Panel Power Input: 12 Vdc, 2.
Rest Factory reset button SFP SFP slot for install fiber SFP 4
Chapter 2 Initial Installation 2 SRE4105T is designed for Plug-n-Play(PnP) and self-configure which not require any software installation to use. When device power on the device, it will start scanning and search for valid LTE backhaul donor eNB and begin the device Plug PnP and provision processes. The PnP and provision process will take approximate 6~7 min. to bring up and activate the device service. 1.
3. Install the Ethernet cable into device WAN port. 4. Another Ethernet cable connector connects to router. 5. Install the Power Adapter DC port into device power jack. 6. When Power & LTE LED steady to flash to green, the device can be used. If the one of LED keeps still flashing at 30 minutes, please call your agent.
3 Chapter 3 Specifications General Specification Connectivity - 4 x LTE External Antennas - Ethernet or Fiber wired connection Power Supply External Power Adapter: Input: AC100～240V~1.6A, 50Hz/60Hz, 0.9A Max. Output: 12 Vdc, 2.5A Operating Requirement Operating Temp. 0ºC to 40ºC Storage Temp. -5ºC to 45ºC Operating Humidity 5% to 90% Non-Condensing Storage Humidity 5% to 95% Non-Condensing Reset button Reset & Info Button LED 4 LED for Status.
Regulatory Requirements FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Safety Information All instructions, warning and caution statements that accompany this equipment must be strictly followed at all times to ensure its safe use. Observe all warning and caution symbols that are fixed to this equipment. This electrical equipment is designed with the utmost care for the safety of those who install and use it.
At least one other trained person must be in attendance, who can immediately and safely disconnect the system if necessary. This second person must be trained in first aid for emergency purposes Some parts of all electrical installations are energized. Failure to follow safe work Practices and the safety warnings may lead to bodily injury and property damage.
Device Surface Cleaning You may clean the device case using a cloth dampened with mild liquid detergent (such as Dawn) and water. Always unplug/disconnect power before apply any cleaning to Device. Warning Do not submerse the Device or its accessories in water or allow water to enter into the case; this may lead to electrical shock and/or damage 1.
Accessories Item Description P/N AC/DC Adapter (without power core) AC100～240V~0.9A, 50Hz/60Hz auto switching, 12 V DC, 2.
