User's Manual
2
Operation
1. PIR LED (Red)
5. Pairing LED (Green)
2. Tamper Switch
6. Battery Cover (Wall
Mount Bracket)
3. Jumper (Walk Test)
4. Battery
Remove the protection film on front panel before installation.
When the battery is installed, the PIR LED will be blinking for 30 seconds and then turn off when the Motion Sensor is ready
to be used.
After the tamper switch is pressed, the Motion Detector will be in normal mode. The PIR LED on the device will illuminate
when the Motion Detector is triggered.
When the Motion Detector is triggered, it will send Basic Set ON (0xFF).
If no movement detected in three minutes, it will send Basic Set OFF (0x00).
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECTED TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
Add (Inclusion) Sensor
For adding in (Inclusion) a network: Put the Z-Wave controller into "Add (Inclusion)" mode, and follow its instruction to add
SW-PIR03N to your controller. This sensor needs to be included before installation.
1. Install the battery and the Pairing LED indicator will be lit for one second to indicate a successful booting.
2. It will blink one time every second while scanning the network.
3. If the network is not found after 30 seconds, the sensor will go into sleep mode. To wake the sensor again, you need to use the
tamper switch to trigger the adding (Inclusion) process, and then the sensor will repeat steps from 2 to 3.
Remove (Exclusion) Sensor
1. Set the Z-Wave controller to "Exclusion" mode.
2. Press the tamper button 3 times within 2 seconds.
3. The PIR LED will light up for 1 second if success.
4. The device will begin to search for a new network.
Association
Associations (Association Command Class Version 2)
This Sensor supports 2 association groups. This has the effect that when the sensor is triggered, all devices associated with the
sensor will receive the relevant reports. Through an association the sensor may control another Z-Wave network device, e.g. a
alarm device, wall plug, lamp etc.