User's Manual

6
Z-Wave Command Classes
• COMMAND_CLASS_ZWAVEPLUS_INFO
• COMMAND_CLASS_VERSION
• COMMAND_CLASS_MANUFACTURER_SPECIFIC
• COMMAND_CLASS_DEVICE_RESET_LOCALLY
• COMMAND_CLASS_POWERLEVEL
• COMMAND_CLASS_BATTERY
• COMMAND_CLASS_NOTIFICATION
• COMMAND_CLASS_ASSOCIATION
• COMMAND_CLASS_ASSOCIATION_GRP_INFO
• COMMAND_CLASS_BASIC
• COMMAND_CLASS_WAKE_UP
• COMMAND_CLASS_FIRMWARE_UPDATE_MD
• COMMAND_CLASS_SENSOR_MULTILEVEL
• COMMAND_CLASS_CONFIGURATION
Z-Wave Configuration
Configuration
Parameter
Function
Size
(Byte)
Configuration
Value
Unit
Default
Setting
Description
1
Configure motion
trigger interval
2
0x0002~0x00
B4
1s
180s
After motion detected, ignores
consequent motion events during
the trigger interval to save battery
power.
If “Walk Test” jumper is
enabled, the interval will be set to
2 seconds and ignores this
configuration.
Notification Type
Switch Type
Status
Notification Type
PIR ON/OFF
0x07
Tamper Switch
0x07
Event
PIR ON/OFF
Close:0x00, Open:0x08
Tamper Switch
Close:0x00, Open:0x03
BASIC Report
PIR ON/OFF
Close:0x00, Open:0xFF
Alarm V1
(Movement)
Alarm Type
0x07
Alarm Level
0x00 (No movement after3
mins )
0xFF (Motion detected)