User's Guide

Operation

1. Normal operation, the LED will not light.

2. The sensor equipped with tamper switch. If the cover of sensor is removed, the

door sensor will send an alarm report to the ZigBee interface controller. Before

replacing the cover, the sensor is under “Awake” mode

：

3. For “Join” a network Put the ZigBee interface controller into “Join” mode, and

following its instruction to add the sensor to controller.

：Join Press < 1 seconds and then start to "Join" processing

While "presee < 1 seconds" , the LED is static on

While running "joint" process, the LED is blinking

：Associate Duration Max >3 seconds for "Join" processing

If joint succesfully, the Green LED will be on 2 seconds and then

off

If joint failed, the Green LED will be off directly.

：Leave Press 10 seconds and then run "Leave" processing