User's Manual
1
SZ-DWS06 Door/Window Sensor Installation Guide
D
oor/Window sensors are designed to secure the perimeter of the residential premise, and provide the ability to
a
dd various automation services. The Door/Window sensor, which consists of a magnet that attaches to a door or
w
indo
w
, will communicate intrusions to the home security system. When the magnet is moved away from the
s
ensor, a signal will be sent to the control panel that sets off an alarm if the security system is armed. Signals can
a
lso be used to activate a chime or convenience lighting based on system settings.
Frequency 2.4GHz
Battery Type CR2450 Battery
Operating Temperature
0° Cto50° C(32°F - 122°F)
Storage Temperature
-20° Cto60° C (-4°F-140°F)
Battery Life 5 Years
Dimension Main Unit: 59 mm x 29 mm x 11 mm (2.32" x 1.14" x 0.43")
Magnet Unit: 59 mm x 10 mm x 11 mm (2.32" x 0.39" x 0.43")
SpacerUnit:59mmx10mmx2mm(2.32" x0.39"x0.078")
This Door/Window sensor needs to be paired before installation.
1. Pull the exposed plastic tab from the sensor.
2. T
he LED indicator will be lit for two seconds to indicate a successful booting.
It will blink three times every 5 seconds while scanning the network.
3. I
f network is not found after 100 seconds, the sensor will be in sleep mode.
You need to use magnet or tamper to trigger a paring process, and then sensor will repeat steps from
1 to
3.
1. Please make sure that the sensor and magnet is located less than 0.25 inch from each other. For optimal
performance, it is highly recommended to install the Door/Window sensor on the fixed frame and the magnet
on the moving part of the door/window. Place the sensor near the top of the door that close to the opening
edge of the door. This is the mounting location for the sensor.
2. U
se the provided double-sided tape on the sensor. Attach the sensor to the door. Press firmly and hold in place
for a few seconds (Figure
1). Secure it with silicone if needed.
3. Use provided double-sided tape on the magnet. Make sure the alignment of both sensor and magnet are facing
each other (Figure2). Press firmly and hold in place for a few seconds. Secure it with silicone if needed.
4. You will also get two spacers which you can use to properly align the magnet with the corresponding sensor
when the door/window frame is not parallel with the door/window.
Peel paper from the provided double-sided tape and place it on bottom of a spacer. Then remove paper from
reverse side of the tape and attach the magnet to the spacer (Figure
3).
5. Spacers are used to raise the level of the magnet to be level/closer to sensor. Install Magnets as shown in
Figure 5
Figure 1
Introduction
Specification
Installation
Pairing Sensor
Figure1
Figure 2 Figure3
Figure 2