User's Manual

1
Door/Window Sensor Installation Guide
Door/
Window sensors are designed to secure the perimeter of the residential premise, and provide the ability to
add various automation s
ervices. The Door/Window sensor, which consists of a magnet that attaches to a door or window, will
communicate
door events to the home security system. When the magnet is moved away from the sensor, a signal will be
sent to
the control panel that
communicates the changed state to the security system. Signals can also be used to activate a chime or
convenience lighting based on system settings.
Frequency 2.4GHz
Battery Type CR2450 Battery
Operating Temperature 0
°
C to 50
°
C (32°F - 122°F)
Storage Temperature -20
°
C to 60
°
C (-4°F - 140°F)
Battery Life 4 Years
Dimension Sensor Device: 51 mm x 29 mm x 11 mm (2" x 1.14" x 0.43")
Magnet: 51 mm x 10 mm x 11 mm (2" x 0.39" x 0.43")
This
Door/Window sensor needs to be paired before installation.
1.
Pull the exposed plastic tab from the sensor. (Figure 1)
2.
The LED indicator will be lit for two seconds to indicate a
Successful booting.
3.
It will blink three times every 5 seconds while scanning the
network.
4.
If network is not found after 100 seconds, the sensor will go
into sleep mode. To wake the sensor again, you need to use
magnet or tamper (Figure 2) to trigger a paring process, and
then sensor will repeat steps from 3 to 4.
1.
Please make sure that the sensor and magnet is located less than 0.25 inch from each other. For optimal performance, it is
highly recommended to install the Door/Window sensor on the fixed frame and the magnet on the moving part of the
door/window. Place the sensor near the top of the door that close to the opening edge of the door. This is the mounting
location for the sensor.
2.
Use the provided double-sided tape on the sensor. Attach the sensor to the door. Press firmly and hold in place for a few
seconds (Figure 3). Secure it with silicone if needed.
3.
Use provided double-sided tape on the magnet. Make sure the alignment of both sensor and magnet are facing each other
(Figure 4). Press firmly and hold in place for a few seconds. Secure it with silicone if needed.
4.
Spacers are used to raise the level of the magnet to be level/closer to sensor. Install Magnets as shown in Figure 5
Introduction
Specification
Installation
Pairing Sensor
Figure 3
Figure 1
Figure 2
Figure 4