User's Manual

ManualsBrandsSercomm ManualsElectronicsZigBee Key Fob

SZ-KFB01 ZigBee Key Fob Manual / Installation Guide

SZ-KFB01 is a professional security token with built-in authentication mechanisms. Just use the Key Fobs

and users can have security control wherever inside or outside of their homes.

Specification

Frequency 2.4GHz 802.15.4 Zigbee system

Battery Type DC3V CR2032 * 1

Communication Range

Open Air：100M (Max)

LED Indicator Red / Green x 1

Operating Temperature

0 C to 50 C (32° - 122°F)

Storage Temperature

-20 C to 70 C (-4° - 158°F)

Battery Life 2 Years

Keys



: Arm All



: Disarm All



: Reserved



: Arm Perimeter

Dimension 56 mm x 38 mm x 16 mm (2.2" x 1.5" x 0.6")

Package Contents

Summary of content (5 pages)

PAGE 1
SZ-KFB01 ZigBee Key Fob Manual / Installation Guide SZ-KFB01 is a professional security token with built-in authentication mechanisms. Just use the Key Fobs and users can have security control wherever inside or outside of their homes. Specification Frequency 2.4GHz 802.15.
PAGE 2
LEDs Power (Red/Green) On (Red) - When any key is pressed. Blinking (Red) - The command is being processed (2 times per second). Blinking (Green):  The LED will blink for 10 seconds when join/leave function is being processed.  The LED will be on for 2 seconds when join/leave function is succeeded and then off. Pre-Intallation 1. Use a Phillips head screwdriver to remove the screw in the back of the device. 2. Remove the back and find the supplied battery. 3.
PAGE 3
4. Install the supplied battery. 5. Put the circuit board back into the device. 6. Tighten the back and the device with the screw. 7. The device is ready to be added to the ZigBee Coordinator.
PAGE 4
Operation  Join Function For “Join” a network, please do the following instruction:  Put the ZigBee Coordinator into “Permit-Joining” mode.  + Arm All button for 1 second. The LED is flashing while Pressed and hold Reserved processing. If the SZ-KFB01 has been joined with the ZigBee Coordinator successfully, the Green LED will be on for 2 seconds and then off. The Green LED will be off instantly if failed.
PAGE 5
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-ence to radio communications.