User's Manual

ManualsBrandsSercomm ManualsElectronicsZigBee Smoke Detector

SZ-SMK01 ZigBee SMOKE ALARM Installation Guide

The SZ-SMK01 is a Smoke Alarm that is designed to detect smoke, which maybe a signal of a fire. This device can provide more

time by making alarms for you and your family to escape before a fire spreads.

Specification

Batter Type 3V lithium battery (CR123A 3V)

Operating Temperature

-10 C to 50 C (14° - 122°F)

Operating Humidity 10% to 85% Non-condensing

Alarm Audibility At least 85 dB at 3 meters

Dimention 120mm (diameter) x 53mm (depth)

Package Contents

LEDs

 Stand-by Mode: The device is under normal operation if the red LED flashes once for 1034 seconds. When the device senses

smoke, the red LED will flash continuously and rapidly while sounds an audible alarm with 3 beeps, pause and 3 beeps.

 Low Battery Mode: The red LED flashes and the device begins to chirp once in 43 seconds. This warning should last for up

to 30 days. Please replace the battery before power is running out to secure your protection.

 Malfunction (Error) Mode: The yellow LED flashes three times and the device generates 3 beeps within 43 seconds. This

indicates the device is malfunctioned and needs to be repaired or serviced.

 Tamper Mode: The device will generate 3 beeps and the yellow LED is steadily on if the smoke alarm is not mounted into

the bracket properly within 5 minutes after the battery is installed.

Summary of content (4 pages)

PAGE 1
SZ-SMK01 ZigBee SMOKE ALARM Installation Guide The SZ-SMK01 is a Smoke Alarm that is designed to detect smoke, which maybe a signal of a fire. This device can provide more time by making alarms for you and your family to escape before a fire spreads.
PAGE 2
Intallation Battery Installation/Replacement 1. Open the battery cover of the device. 2. Install the supplied battery correctly. 3. Close the battery cover. 4. Install the bracket. Note: you will hear a chirp after install the bracket which indicates the device is receiving battery power. Recommended Battery Type Please use the following suggested battery. Use of a different battery may cause a detrimental effect on alarm operation.
PAGE 3
Wall Mounting 1. Draw a six inches horizontal line at the place where you are going to install the device. 2. Rotate the mounting bracket counterclockwise to remove it from the device. 3. Draw 2 marks to locate the screws. 4. Drill two holes at the marks and insert screws and wall plugs. 5. Attach the bracket to the wall by using the supplied two screws and wall plugs. 6. Attach the device onto the mounting bracket and turn it clockwise to fix it into place.
PAGE 4
3. Test/Silence Button The Test button is used to test if the device is working properly and mute the SZ-SMK01 during alarm.  Test Press the Test button for about 4 seconds until it alarms. The device will generate 3 beeps, pause and 3 beeps. While the Alarm (red) LED will flash continuously and rapidly.  Silence If the device is alarming, press the Test button will have it silenced. If the smoke still remains after 10 minutes, the device will alarm again.