User's Manual

ManualsBrandsSercomm ManualsElectronicsZigBee Water Sensor

SZ- WTD01 ZigBee Water Sensor Installation Guide

Specification

Frequency 2.4GHz

Battery Type DC 3V, CR2032x2

Application Basements, laundry rooms, bathrooms, kitchens etc

Water Sensor Cable Length 3M (10 ft)

Operating Temperature

0° C to 50° C (32° - 122°F)

Storage Temperature

-20° C to 70° C (-4° - 158°F)

Battery Life 2 years

RF Range

Open Air：100M

Dimension Main Unit: 65 mm x 30 mm x 13 mm (2.60" x 1.18" x 0.51")

Detector Unit: 45 mm x 15 mm x 10 mm (1.77" x 0.59" x 0.39")

Package Contents

Summary of content (4 pages)

PAGE 1
SZ- WTD01 ZigBee Water Sensor Installation Guide Specification Frequency 2.4GHz Battery Type DC 3V, CR2032x2 Application Basements, laundry rooms, bathrooms, kitchens etc Water Sensor Cable Length 3M (10 ft) Operating Temperature 0° C to 50° C (32° - 122°F) Storage Temperature -20° C to 70° C (-4° - 158°F) Battery Life 2 years RF Range Open Air：100M Dimension Main Unit: 65 mm x 30 mm x 13 mm (2.60" x 1.18" x 0.51") Detector Unit: 45 mm x 15 mm x 10 mm (1.77" x 0.59" x 0.
PAGE 2
Intallation Intallation 1. Insert a flat screwdriver into the notch of the casing. Twist carefully to open the front cover. 2. Install the supplied CR2032 batteries properly. Note: Please observe the battery polarity to ensure the correct connections while installing the batteries. Use only the CR2032 batteries for replacement. 3. Attach the front cover to the device. 4. Hold the sensor near the top of the door, close to the opening edge of the door. This is the mounting location for the sensor. 5.
PAGE 3
For "Join" a network, please do the following instruction: • • Put the ZigBee Coordinator into “Permit-Joining” mode. • Press the Join/Leave button for less than 1 second. The LED is blinking while processing. If the sensor has been joined with the ZigBee Coordinator successfully, the Green LED will be on for 2 seconds and then off. The Green LED will be off instantly if failed.
PAGE 4
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.