User's Manual

Installation

2. Connect LAN Cables

Use standard LAN cables to connect PCs to the Switching Hub ports on the ADSL VoIP

Router. Both 10BaseT and 100BaseT connections can be used simultaneously.

If required, connect any port to a normal port on another Hub, using a standard LAN cable.

Any LAN port on the ADSL VoIP Router will automatically function as an "Uplink" port

when required.

3. Connect ADSL Cable

Connect the supplied ADSL cable from to the WAN port on the ADSL VoIP Router (the

RJ11 connector) to the ADSL terminator provided by your phone company.

4. Power Up

Connect the supplied power adapter to the ADSL VoIP Router and power up.

Use only the power adapter provided. Using a different one may cause hardware damage

5. Check the LEDs

• The Power LED should be ON.

• The Status LED should flash, then turn Off. If it stays on or blinking after 60 seconds, there

is a hardware error.

• For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the PC is

also ON.)

• The WLAN LED should be ON

• The WAN LED should be ON if ADSL line is connected.

For more information, refer to Front-mounted LEDs in Chapter 1.