User Manual

Installation - Wireless Network Camera

1. Assemble the Camera

Screw the supplied antenna to the mounting point on the rear.

Attach the Camera Mount to the camera.

2. Connect the LAN Cable

Connect the Wireless Network Camera to a 10/100BaseT hub or switch, using a standard

LAN cable.

For the Wireless Network Camera, this disables the Wireless

Interface, because only one interface can be active.

The LAN cable should only be connected or disconnected

when the camera is powered OFF. Attaching or detaching the

LAN cable while the camera is powered on does NOT switch

the interface between wired and wireless.

3. Power Up

Connect the supplied 5Vpower adapter to the Wireless Network Camera and power up.

Use only the power adapter provided. Using a different one may cause hardware damage.

4. Check the LEDs

• The Power LED will turn on briefly, then start blinking. It will blink during startup, which

takes 15 to 20 seconds. After startup is completed, the Power LED should remain ON.

• The Network LED should be ON.

For more information, refer to Physical Details - Wireless Network Camera in Chapter 1.