User Manual

Chapter 5

Web-based Management

This Chapter provides Setup details of the Wireless Network Camera’s Web-

based Interface. This Chapter is for the Camera Administrator only.

Introduction

The Wireless Network Camera can be configured using your Web Browser. The Wireless

Network Camera must have an IP address which is compatible with your PC.

The recommended method to ensure this is to use the supplied Windows-based Wizard, as

described in Chapter 2 - Basic Setup.

Connecting to Wireless Network Camera

• If you have run the Windows-based setup Wizard, the final screen provided a button Web

UI. Clicking this button will immediately connect to the Wireless Network Camera, using

your Web Browser.

• If using only your Web Browser, use the following procedure to establish a connection

from your PC to the Wireless Network Camera:

• Once connected, you can add the Wireless Network Camera to your Browser's Favorites

or Bookmarks.

Connecting using your Web Browser

1. Use the Windows utility to get the IP address of the Wireless Network Camera.

2. Start your WEB browser.

3. In the Address box, enter "HTTP://" and the IP Address of the Wireless Network Camera.

4. You will then be prompted for a username and password.

• If using the default values, enter administrator for the name, and leave the

password blank.

• Otherwise, enter the Administrator ID and Administrator Password set on the

Maintenance screen.