User Manual

Physical Details - Wireless Network Camera

Front - Wireless Network Camera

Lens No physical adjustment is required or possible for the lens, but you

should ensure that the lens cover remain clean. The image quality is

degraded if the lens cover is dirty or smudged.

Microphone The built-in microphone is mounted on the front.

Power LED

(Green)

On - Power on.

Off - No power.

Blinking - The Power LED will blink during start up. This will take

15 to 20 seconds.

Active LED

(Green)

Off - No user is viewing the camera.

Blinking - User(s) is viewing the camera.

Network LED

(Green)

On - Wireless or LAN connection is detected.

Off - Wireless or LAN connection is not detected

Blinking - Data is being transmitted or received via the LAN or

Wireless connection.

Rear - Wireless Network Camera

Antenna Attach the supplied antenna here. The antenna is adjustable; best

results are usually obtained with the antenna positioned vertically.

SPKR out If required, an external speaker can be attached here.

Power Input Connect the supplied 5V power adapter here. Do not use other

power adapters; doing so may damage the camera.

LAN port Use a standard LAN cable to connect your Wireless Network

Camera to a 10/100BaseT hub or switch.

Note:

• Attaching the LAN cable will disable the Wireless interface.

Only 1 interface can be active at any time.

• The LAN cable should only be connected or disconnected when

the camera is powered OFF. Attaching or detaching the LAN

cable while the camera is powered on does NOT switch the

interface between wired and wireless.

Reset Button This button is recessed; you need a pin or paper clip can be used to

depress it. It can be activated at any time the camera is in the

"ready" mode.

• Restore Default IP Address. When pressed and released, the

Wireless Network Camera will reset to DHCP Client.

• Restore Default IP Address, Administrator ID, and

Administrator password. When pressed and held for 3

seconds, the IP address, Administrator ID, and Administrator

Password settings will be set to their default values.

• IP address: DHCP Client