User's Manual

Master-Unit Installation and Testing

1. Install four AA size rechargeable NiMH batteries (user provided) in battery

compartment at bottom of unit. Warning: Do not use regular batteries as

charging of this type can cause battery leakage and damage to the

CentralAlert

unit. (The unit works without batteries; they may be inserted

for back up, in case of power outage)

2. Plug AC adapter into nearest electrical outlet and connect adapter plug to

CentralAlert

Master-Unit as shown.

3. Connect bed shaker to

SHAKER-1 output jack.

4. Connect phone cord to

PHONE-1 outlet at the back of Master-Unit, then

plug the other end into wall phone jack.

5. Set the

SPEAKER ( - on left side of unit) to desired volume setting (Hi-

Lo-Off).

6. Press

SOS button on top of unit (next to Motion button) to test. Verify that

alert outputs (speaker, flasher, shaker, and display) last for 30 seconds, then

stop.

7. Verify that flasher can be toggled ON and OFF using

SNOOZE / RESET

button.

Set the Clock:

1. Slide

SET switch (on right side of unit) to TIME

position and push

HR & MIN buttons to set time. The

unit’s face will show the AM time with a lighted dot

beside “Sun AM” icon. No dot means PM. Holding in

HR/MIN switch to forward the hours will not work. Push

button repeatedly.

2. After completing time setting, slide

SET switch to

RUN position for normal clock operation.