Technical information

10
How to Customize OGM 1 & OGM 2:
YoucancustomizeanyofthetwoOGM’s.Forexampleyou
can have the first OGM on default and the second OGM
customize when you go on vacation. To do this, follow the
steps below:
1. While in the stand by mode, press and hold “OGM”
key for about 3 seconds until it announces “To record
new OGM, please speak after the tone”,.
2. Speak clearly and you can record up to 30 seconds.
Press “STOP” when finished.
3. Itwillthenannounce“YournewOGMmessage
is:……………..” If you are not satisfied, repeat the
steps 1-2.
Reset to factory default OGM:
1. Press the “OGM” key once to play the OGM, press the
“DELETE” key once.
2. It will delete the recorded OGM and return to the
default OGM.
Call Intercept Function:
This allows you to pick up an incoming call while someone is
leaving you a message.
1. Press “CALL INTERCEPT”. It will pick up the call and
activate the speaker and you can start talking hands
free. If needed, press “SET-MUTE” key to mute the
microphone. The display will show UU. To un-mute,
press “SET-MUTE” again..
2. To end call, press “CALL INTERCEPT.
Setting the Number of Rings:
1. While in standby, press the “SLOW” key once to see
the number of rings selected. (Default 4 rings)
2. Press and hold the “SLOW” key for 3 seconds and
it will announce the number of rings you have it set
to.
3. Press “VOL+” or “VOL-“ to change the number of
rings or Toll Saver.
4. Press “SLOW” again to save and it will announce
“Call will be answered after “#” of rings”.
Note: Toll Saver allows you to call in and check for any
new messages without incurring any long distance toll
charge. If there are new messages, the VM-150 will
answer at 3 rings; otherwise, it will answer at 6 rings.
This gives the user time to hang up quickly without
incurring any toll charges.
New Message Audio Alert On/Off Setting:
Advanced Operations