Technical information

12
setting. If day/time was not set, it will announce
“Please set day and time”.
2. To set day and time, press and hold “SET-MUTE”
key for 3 seconds until it announces “Set year”.
The display shows the last two digits of the year,
for example “10”. Press “Vol. +” or “Vol. –“ key to
change the year.
3. Press “SKIP” once to save, then the machine
announces “Set month”. The display shows the
month, for example “1”. Press “Vol. +” or “Vol. –“key
to change the month.
4. Press “SKIP” once to save and then the machine
announces “Set date”. The display shows the date,
for example “01”. Press “Vol. +” or “Vol. –“key to
change the date.
5. Press “SKIP” once to save and then the machine
announces “Set hour”. The display shows the hour,
for example “00” Press “Vol. +” or “Vol. –“key to
change to the correct hour. (The clock is in the 24-
hour format, if it is 5 in the afternoon, you need to
set it to 17. But the VM-150 will announce in the 12
hour format; for example, it will say “5PM”.
6. Press “SKIP” to save and then the machine
announces “Set minute”. The display shows the
minute, for example “00”. Press “Vol. +” or “Vol.
–“key to change to the correct minute.
7. Press “SET-MUTE” to save and it will announce the
current day/time setting, for example: “November 9,
Thursday, 5:15 PM”
Note: Unless you have installed the power back up
batteries, the day/time setting will be lost when the
power cord is unplugged or when there is a power
outage.
Recoding a Memo:
This allows you to record a voice message as a reminder
or as a message to someone and it will be shown as a
new message. To record such a message, follow these
steps:
1. While in standby mode, press and hold “MEMO”
until it announces “Please speak after the tone, to
end recording press stop”.
2. Speak clearly and you can record up to 3 minutes,