SLPAC12 Portable Air Conditioner Fan and Dehumidifier
CONTENT I. Notes.................................................................................................................................. 3 II. Features and Components..................................................................................... 4 III. Installation and Adjustment................................................................................6 IV. Control Setting........................................................................................................... 8 V.
Please keep the manual for later review, and read the manual carefully before use. I. Notes Notes: • The air conditioner is only suitable for indoor use, and is not suitable for other applications. • Follow local grid interconnection rules while installing the air conditioner and ensure that it is properly grounded. If you have any question on electrical installation, follow the instructions of the manufacturer, and if necessary, ask a professional electrician to install it.
• Do not use insecticide sprays or other flammable substances near the air conditioner. • Do not wipe or wash the air conditioner with chemical solvents such as gasoline and alcohol. When you need to clean the air conditioner, you must disconnect the power supply, and clean it with a half-wet soft cloth. If the machine is really dirty, scrub with a mild detergent. • Children shall not play with the appliance. Cleaning and maintenance shall not be made by children without supervision. II.
12. Power COrd Hook 13. Handle 14. Air vent exhaust 15. Continuous Drainage hole 16. CON filter screen 17. Air Inlet Grille 18. Drainage hole 19. Power Cord 20. Power Cord Plug 7 8 9 10 11 13 12 15 14 16 17 18 19 20 5 www.SereneLifeHome.
III. Installation and Adjustment 1. Installation: Warning: before using the mobile air conditioner, keep it upright for at least two hours. The air conditioner can be easily moved in the room. In the moving process, ensure that the air conditioner is in the upright position and should be placed on a flat surface. Do not install and use the air conditioner in the bathroom or other humid environments. 1.
2. Slide open the window plate assembly. Adjust their opening distance to bring both ends of the assembly into contact with the window frame, and fix into place with screw. Figure 2 Figure 3 1.3 Install the unit 1. Move the machine with installed heat hose and fittings near the window. The distance between the unit and walls or other objects shall be least 50cm (as shown in Figure 4) Figure 4 2.
Figure 5 Figure 6 Important Notice The length of the exhaust hose shall be 280~1,500mm, and this length is based on the specifications of the air conditioner. Do not use extension tubes or replace it with other different hoses, or this may cause a malfunction. Exhaust must be unobstructed; otherwise it may cause overheating. IV. Control Setting I. Operating Instructions 5 1 2 www.SereneLifeHome.
1. Power key 2. Mode selection key 3. Window display 4. Down key 5. Up key 6. Wind speed selection key 7. Timing key When power is connected to the unit for the first time, buzzer will play power-on music, and then the machine will get into standby status. 1. Power Key: Press the key to turn on and turn off the machine. 2. Mode Selection Key: When power is on, press the key to switch between cooling air supply dehumidification cooling .mode. 3. Window display 4.5.
II. Operating Instructions of the Remote Control Instructions of key operation of the high-quality remote control are as follows: 1. Power: Press the key to turn ON or turn OFF the machine. 2. Mode: Press the key to switch between cooling, air supply, dehumidification. 3. Up: Press the key to increase temperature and timing set value. 4. Down: Press the key to reduce temperature and timing set value. 5. Fan: Press the key to select high, medium and low wind speed. 6.
of this chapter). After the water is emptied, the machine will automati cally return to the original state. 3.3 Automatic Defrosting (cooling models have this function): The machine has automatic defrosting function: during defrosting, heating symbol on the display screen will flash. 3.4. Protection Function of the Compressor To increase the service life of the compressor, it has a 3-minute delay booting protection function after the unit is turned off and on again. V. Drainage Instructions 1.
2. Continuous drainage (only applicable to cooling and dehumidification mode), as shown in figure 2: 1. Unscrew the drainage cover, and unplug the water plug. 2. Set the drainage hose into the water outlet. 3. Connect the drainage hose to the bucket. VI. Maintenance Figure 2 Cleaning: Before cleaning and maintenance, turn off the machine and unplug. 1. Clean the surface Clean the surface of the machine with a wet soft cloth.
2.1 Clean the upper filter screen frame 1. Clasp the wedging block of the EVA filter screen frame with hands. Force down from the outside to remove the EVA filter screen frame. Unscrew 4 screws fixing the EVA filter screen and rear housing to remove the EVA filter screen (as image shown) 2. With vacuum cleaner, vacuum off all lint, and dander traped on filter. 3. Put the EVA filter screen into warm water with neutral detergent (about 40°C/104°F) and dry it in the shade after rinsing clean. 2.
VII. Troubleshooting Do not repair or disassemble the air conditioner by yourself. Unqualified repair will void the warranty, and may cause damage to users or their properties. Problems Reasons There is no electricity Solutions Turn it on after connecting it to a socket with electricity. Reset circuit breaker on the power cord The overflow indicator displays The Discharge the water inside.
If problems not listed in the table occur or recommended solutions do not work, please contact the professional service organization. Intelligent Detection Function Code E1 E2 E4 FL Meaning The hose temperature sensor is abnormal The room temperature sensor is abnormal Anti-freeze protection Full water VIII. Appendix 1 2 3 4 Fuse Parameters Type: FSD or 50F Voltage: 250V Current: 3.
