Instructions / Assembly

3
www.PyleUSA.com
2
www.PyleUSA.com
IV. SAFETY INSTRUCTIONS
• Warning: In order to reduce the risk of injury, keep out of reach
of children. Always supervise children and incapacitated person
contacting or using this air pump.
• Warning: Keep the packaging materials away from children
• Warning: This product is not applicable for persons with
declining physical strength, sensory ability or mental capacity,
and person lack of skill unless they are under the protection of
their guardians, supervised and directed at the same time.
• Warning: Before moving, maintaining, repairing or adjusting
this product, pull out the DC plug from the socket.
• Warning: Please do not bury the wire in soil, and place in a
safe environment where it won't be damaged by mower or
other equipment.
• Warning: If power wire is damaged, the power wire must be
changed by the manufacturer or its service agent or similar
authorized personnel, in case of any risk.
• Warning: DON'T PLUG OR PULL THE DC PLUG if you are
standing in a place with water or your hands are wet.
• Warning: Before inating, please pay attention to check the
maximum bearable pressure of the inatable product because
the air bag may be damaged upon exceeding the maximum
bearable pressure.
• Warning: The purpose of using this product is limited to the
description in the instruction book.
• Warning: Before using, please check the cigarette lighter
socket to make sure that there is no rust or residue inside. The
cigarette lighter socket with poor electric conduction may
cause overheating of the product or power source, which will
damage the product.
（Figure 1）
（Figure 2）
V. INFLATION OPERATION
• Connect the end with Flexible conduit adaptor of the hose
with the air pump ination inlet (1), and twist clockwise to
tighten, as Figure 1.
• Install the other end of the hose into the supporting air tap of
the air bag (step① in Figure 2), and twist clockwise to tighten
it, and then insert the ination valve of the air bag and twist
clockwise to x it (step② in Figure 2).
• Plug the DC plug into 12V DC socket.
• Press the pressure unit toggle button to select the unit
you need.
• Press the pressurizing button or decompressing button
to set the pressure value you need, with the range of the
pressure value from 0 to 16PSI, (1PSI=0.0689BAR)
• After nishing the above steps, press the power switch button
to start to inate.
• During the inating process, you can press the pressurizing
button or decompressing button to increase or
reduce the pressure value, press the pressure unit toggle
button to switch the unit, and press the On/O button
to stop.