AGE: 14+ by
4-AXIS AEROCRAFT SPEED CONTROL: 30%60%100% TAKE PHOTO RETURN VOICE CONTROL SHOOT VIDEO PHOTO&VIDEO PLAYBACK ALTITUDE HOLD SHOW / HIDE SETUP MENU CAMERA INVERSION 3D VIEW HEADLESS MODE GYRO CALIBRATE FLIGHT PATH SHOW/HIDE CONTROL INTERFACE GRAVITY SENSOR MODE 360° FLIP 1. PHOTO/VIDEO 2. POWER ON/OFF 3. HIGH/MEDIUM/LOW SPEED 4. 360° FLIP 5. LEFT STICK (ASCEND/DESCEND/ TURN LEFT/TURN RIGHT) 6. RIGHT STICK (FORWARD/BACKWARD/ LEFT AND RIGHT SIDE FLYING) 8. FORWARD/BACKWARD TRIM 7.UNLOCK 9.
FUNCTION KEYS & NAME DESCRIPTION Serial Function keys / Number Names Function / Effect 1 Photo/Video Short press to take photo ; long press 3 seconds to take video , short press again stop taking video. 2 Power ON/OFF Remote Control POWER ON/OFF switch 3 High/medium/low speed Adjust the drones flying speed in all directions. 4 360° Flip This button will cause the drone to do a flip in the air.
DRONE POWER SWITCH INTRODUCTIONS To turn ON the drone, press the power button located on top of the drone. To turn OFF the drone, PRESS and HOLD the power button for 3 seconds. REMOTE CONTROL BATTERY INSTALLATION 1. Remove the battery cover from the back of controller (Fig. A) 2. Install 4 “AA” batteries into the controller, make sure to install batteries to their correct polarity. (Fig. B) Do not mix old and new batteries or battery types. 3. Replace the battery cover Fig.
FLIGHT PREPARATION 1. Operate in wide open spacious areas. Do not operate in bad weather, or windy conditions. Avoid flying close to people, animals, and obstacles. 2. Make sure the battery is installed correctly and that the battery cover closes properly. Turn on the drone by pressing the power button at the top, which will cause the lights to flash. Now place the drone on a flat surface and it is ready to be synced with the controller. 3.
COMMON PROBLEM AND SOLUTION INSTRUCTION: THE PROBLEM REASON COUNTER MEASURES The drone lights are flashing, but it wont sync with the remote. 1. Frequency modulation between the quadcopter and remote control is not operated correctly. 2. Insufficient battery power. 1. Refer to the Preparation for taking off, and re-modulate the frequency. 2. Recharge the battery. The drone's blades are 1. Insufficient battery rotating, but the drone power. 2. The blades are will not take off. distorted.
