Operating instructions

Gas Conversion for Top Convertible Pilot (Series 019065X) – PART B

Instructions for converting SIT 190 series pilot burner injection from NG to LPG and from NG to LPG only. This

information should be considered as supplemental to the Appliance Manufacturer’s Instructions.

WARNING: The installation of this conversion kit must only be undertaken by a qualified and certified gas

appliance installer.

1. Shut off the gas supply to the appliance.

2. Allow the pilot burner to cool to room temperature.

WARNING: Touching a hot pilot burner can

result in injury.

3. The pilot hood is held in place by spring pressure.

Remove the hood by pulling it directly up from the

pilot bracket (a).

4. Insert a 5/32” or 4mm Allen wrench into the

hexagonal key-way of the injector (b), and rotate it

4 counter-clockwise until it is free of the injector

journal (c).

5. Verify that the new injector is proper for the

application. The injector size is stamped on the

side of the injector near the top. LPG injectors have

a groove machined around their circumference

near the top, while NG injectors do not have a

groove (e). Refer to the Appliance Manufacturers

instruction sheet for the proper injector size.

6. Insert the Allen wrench into the end of the injector.

Then, insert into injector journal, and rotate the

injector clockwise until a torque of 9 in-lbs is

achieved.

7. Replace the pilot hood by aligning the tab on the

base of the hood with the slot in the side of the pilot

journal, and push the hood down, directly onto the

pilot bracket (d). The hood must sit squarely on the

bracket for proper operation. Check to insure that

the hood is properly seated onto the pilot bracket.

(a)

(b)

(c)

(d)

(e)

WARNING: This conversion kit must only be applied as part of a conversion kit supplied by the appliance

Manufacturer for the specific appliance, and type of gas being converted.

INSTALLER NOTICE: These instructions must be left with appliance.