Specifications

Control25
Degree Minute s(DM) instruction
For example : the DM was cumulated to -160 in this time.
1 minutes later when the Feed water temperature higher than desired temperature for 1ć.
10X1=10 , Degree Minute= -150;
Another 1 minutes later when the Feed water temperature higher than desired temperature for
2ć. 10X1=10, Degree Minute= -140;
Another 1 minutes later when the Feed water temperature higher than desired temperature for
3ć. 10X1=10, Degree Minute= -130;
Another 1 minutes later when the Feed water temperature higher than desired temperature for
4ć. 10X1=10, Degree Minute= -120;
……………………
Compressor off when Degree Minute reach 0 (adjustable) .
The relationship between compressor (on and off) and DM,the relationship between heater(on and off)
and DM.
The relationship between compressor and DM
The above chart is describing that running of compressor and electrical heater depend on Integral
The compressor’s DM is -60 start, 0 is off, A0=-60 startup.
Electrical heater 1 ’s DM is -500 start,when the feed water temperature reach the setting value the electrical
heater is off, A0+A2=-60-440=-500 start up.Electrical heater 2 / 3 is the same principle.
T=T1-Ts+2
ć
+1.0
+0.5 0
01
-1 2
-2 3
-3 4
-4 5
-56
-6 7
-7 8
9
The constant temperature function is only available in Room heating, but not in water tank heating.
Constant temperature function has two kinds: Integral (DM) and Constant room temperature
1. The constant area diagram: T1, room return water temperature, Ts, room air
setting temperature
or feed water temperature.