DragonRC 2.4GHz Transmitter Manual

2.9 TH-CURV

TH CURV THROTTLE CURVES

This function makes the throttle high side and brake side direction servo operation quic-

ker or milder. It has no effect on the servo maximum operation amount. For the high side,

selection from among three kinds of curves (EXP/VTR/CUR) is also possible.

Note: When the course conditions are good and there is no sense of torque at the power

unit, set each curve to the +side(quickside). When the road surface is slippery and the

drive wheels do not grip it, set each curve to the - minus (mild) side.

Note: Brake side only has EXP curves.

1. Press ‘Roller’ to see FUNCTION MENU.

2. Use the roller to select the TH CURV function and press the roller.

3. Press ‘Roller’ to select a setting.

4. Use the roller to change the value.

5. Press ‘Back’ again to return to save and return to FUNCTION MENU, press back again

to return to the Main Screen.

TH-CURV 10.2V TH-CURV 10.2V TH-CURV 10.2V

M: EXP

R: 43

M: EXP

R: -32

M: EXP

R: -32

BR: -80

Neutral

TH.POS

Quick forward (R:0~100) Mild forward (R:0-100~0) Mild backward (BR:0-100~0)

Adjustment method for EXP curve.

- Press ‘Roller’ to select EXP at setup item ‘M’.

- Select setup item ‘R’ and make the following adjustments:

1. Forward side adjustment: Use the roller to change to dedesired rate value.

A positive EXPO value increases the sensitivity around the center while a negative

decreases its sensitivity.

2. Brake side adjustment: Select the setting item ‘BR’ by pressing the roller, and use the

roller to change to the desired rate value. A positive BR value increases the sensitivity

around the center while a negative value decreases its sensitivity.

3. When ending setting, return to the initial screen by pressing the ‘Back’.